set up the circuit with two LEDs in parallel

 

Note that the supply current for the parallel circuit, 2.2 mA, is higher than the
supply current for the series circuit, 1.4 mA, even though the same components
are used in both circuits. Connecting circuit components in parallel draws more
current from your source than connecting them in series


Electronic for dummies 3rd edition

Comments

Post a Comment

Popular posts from this blog

voltage divider in action

Image
  Resistors can be used also to reduce the voltage supplied to different parts of a circuit. »» One 6-volt battery (4*1.5)  »» jumper wire  »» One 2.2 kΩ resistor »» One 3.3 kΩ resistor  »»breadboard   Next, use your multimeter set to volts DC to measure the voltage across the bat- tery and across the resistors. My measurements show that the actual battery voltage is 4.8 V Vout (the voltage across the 2.2kΩ resistor) is 1.9 V. and Vout (the voltage across the 3.3kΩ resistor) is 2.9 V. and
Read more

Kirchhoffs Voltage Law

Image
  Kirchhoffs Voltage Law or KVL, states that “in any closed loop network being driven by a voltage source, the total voltage around the loop is equal to the sum of all the voltage drops within the same loop” which is equal to zero. 1. Two led series circuit Voltage across battery: 6 volts Voltage across resistor: 2.4 volts Voltage across led1: 1.8 volts Voltage across led2: 1.8 volts
Read more

Limiting current

Image
  I used 3 type of resistor  3.3KΩ - 2.2kΩ - 1kΩ parallel circuit  in which each branch contains a different value of resistance. For higher values of resistance, the cur- rent that passes through that branch is restricted more, so the LED in that branch emits less light.
Read more